Pacific Kiln Elevator FlashFire Dewax System
This Elevator Flashfire Dewax System was built in 2018, S/N: 0118-107 This system has (9) mold drain locations, CAT II afterburner and is ready go to work in your foundry.
All the components are new and the unit was completely factory tested and adjusted. This will give the buyer a factory guarantee of condition and operation. The specification is as follows:
“Elevator” FlashFire Dewax System
Model No.: EFFDWS-9484836
Load Area: 48” W X 48” D X 36” H
Maximum Operating Temperature: 2000°F
Normal Operating Temperature: 1800°F
Electrical: 220 VAC, 1PH, 60 HZ, 40 Amps
Natural Gas Pressure Required: 1 PSI Minimum, 5 PSI Maximum
Afterburner: Category II. This afterburner is designed to reduce VOC and particulate emissions 99%+ with a maximum mold wax load of 14.2 lbs. and maximum burn rate of 2.8 lbs. per minute Documentation is included for air quality permit application.
Burner System: Main Burners are two (2) Pacific Kiln 4” Power Burners (500,000 BTU/H Max. Each)
Afterburner is two (1) Pacific Kiln 4” Burner (1,050,000 BTU/H Max.)
Flame Safety: 100% Fireye Flame Safe w/ purge, auto spark ignition and air safety.
Temperature Control: Honeywell UDC-2500, Single program controller with relay output, Hi/Lo fire control
Options included on this System:
High Limit Safety Controllers UDC-2500 Limit
1 ½” Safety Fuel Train
Automatic Furnace Pressure Control Damper System
Terms: 100% prior to shipment
NOTE: This Elevator FlashFire Dewax System is available for immediate delivery
We hope this unique offer meets with your approval. If you have any additional questions, please contact us at the above numbers or e-mail firstname.lastname@example.org.